Turning homework to prevent injury, the operator should do the following:
(1) wear protective clothing tight, not to open the cuffs, with long hair should wear protective caps, operation should not wear gloves.

(2) loading and unloading machine spindle to chuck after shutdown, the power can not be extracted through the use of motor chuck.

(3) workpiece clamping chuck, dial, the protruding part of Centennial folder shield to be used so as not to twist clothes or live in other parts of the body; If there is no protective cover, operation should be strict attention to a safe distance.

(4) with the top clamping workpieces to the attention of the top is fully consistent with the central hole, which can not be damaged or skew the top. Should be used before the top, the center hole clean, leading to the top after Tailstock prison.

(5) should be used for turning the workpiece center slender frame or with the tool, there should be some signs grow lathe.

(6) The turning of the workpiece to be irregularly shaped block loading balance, and to try to balance and then begin cutting.

(7) to secure clamping tool, part of head not to extend beyond the blade height of 1.5 times the垫片刀下the shape, size, body with a knife shape, size line should be as little as possible垫片Erping .

(8) should be used to hook a timely manner cutting down to clear debris and spiral banded cuttings, should not have a direct hand-out. In order to prevent chip wounding. Should be at a suitable location on the installation of baffles.

(9) In addition to lathe equipped with automatic measuring operation at the gauge, the measurement of the workpiece should be parking, and tool carrier to a safe place.

(10) with emery cloth removing material from the workpiece, the tool should be moved to a safe place and pay attention to hands and clothing, not to allow access to the workpiece surface.

(11) with grinding holes can not support the emery cloth with your fingers, it should be replace with a wooden stick, but not excessive speed.

(12) to ban the use of tools, fixture, or workpiece on the lathe or on the spindle gearbox.