1. Boot before the deal with CNC lathe detailed and thorough examination, including the operation panel, guide face, claw card, tailstock, tool holder, tool and so on, to confirm correct operational rear.
2. CNC lathe after the power to check the switches, buttons and keys are in working order, flexible, machine tool any abnormal situation.
3. Program input should carefully check the code, address, value, sign, decimal point and the grammar is correct.
4. Right measurement and calculation of the workpiece coordinate system, and check the results.
5. The importation of the workpiece coordinate system, and coordinates, coordinate values, sign, carefully check the decimal point.
6. Not loaded workpiece prior to operation of a space program, successfully carried out can watch the procedures, tools and fixture installation is reasonable, whether or not super-way situation.
7. Test Express rate cut when the switch must be hit low gear.
8. Try cutting feed when the running tool to the workpiece at 30 ~ 50 mm, the feed must be maintained, the authentication and the X-axis Z-axis coordinates of the remaining values are consistent with the processing procedures.
9. Try cutting and processing, the grinding tool and replacement of the tool, the tool to re-survey the location and modify the value of a knife and the knife up its fill.
10. The revised procedures, it is necessary to carefully check on the amendments.
11. Must be confirmed before we can start Clamping machine tools, workpiece rotation is prohibited when the measurement, the workpiece touch.
12. Beat the workpiece operation there, playing Buffeting, abnormal sounds, such as abnormal loose fixture must deal with parking.
13 emergency stop should be re-tool "back to zero" operation, in order to run the program again.